|
When first start program, XtraSense will try to search system for a list of installed cameras/video capture devices and create a profile for each of the camera/device found. Depending on the license purchased, the maximum number of cameras enabled may vary from 4 to 16. The screens below are 9 camera interface and visual map.
XtraSense Main Interface
|
|
Camera status indicator
|
|
System status indicator
|
|
Camera title/description
|
|
sensor status indicator
|
|
Capture a frame
|
|
show visual map
|
|
Turn FTP on/off
|
  
|
switch between 4, 9 and 16 camera view mode
|
|
Start/stop recording
|
|
System configuration
|
|
Arm/disarm camera
|
|
|
XtraSense Visual Map
The visual map shows when you click on show/hide visual map button. The map is used to display sensor and camera locations visually on a floor plan. When motion is detected or sensor alarm is triggered, the corresponding indicator on visual map will turn red so that you know where is the actual location of intrusion or alarm.
|
|